BPV-F1, BPV-T1 (without manual override) (24VDC) (compatibility F1-81, -101 and T1-121)

BPV-F1, BPV-T1 (without manual override) (24VDC) (compatibility F1-81, -101 and T1-121)
BPV-F1, BPV-T1 (without manual override) (24VDC) (compatibility F1-81, -101 and T1-121)
BPV-F1, BPV-T1 (without manual override) (24VDC) (compatibility F1-81, -101 and T1-121)
BPV-F1, BPV-T1 (without manual override) (24VDC) (compatibility F1-81, -101 and T1-121)

Part number: 3787203

To Favourites
Recommend
Print
Comparison
Question about the product
Details
Info
Details

BPV-F1 and BPV-T1 bypass valve
• The bypass valve is mainly utilised in applications
where the F1 pump is driven from the crank-shaft
through a cardan shaft, or when it is installed on an
engine PTO.
• The BPV bypass valve should be disengaged during
transportation when the pump is operating constantly
and the engine is running at max rpm; the hydraulic system is not sized for the large flow that would
otherwise go through it.

• The BPV valve substantially reduces the energy
loss during transportation.
• The valve installs directly on top of the pump end
cap with a pressure port ’banjo’ fitting and an inlet
port spacer bushing with two cap screws; refer to
the illustration to the right.

• As the BPV valve is symmetrical, it can be ’turned
180°’ to prevent interference with chassis components; it can be utilised for either left hand or right
hand pumps.
• The valve function must only be activated or
released (by means of the 24 VDC solenoid)
at
no-load (below 20 bar) system pressure.

Bypass valve type BPV-F1-25 to -101 and BPV-T1-81 and -121
Max pressure, continuous (bar) 350
intermittent (bar) 400
Solenoid voltage (VDC) 24, (12)
Power requirement (W) 14
Operating mode Activated solenoid: Check valve closed!



Info
Max pressure, continuous (bar)
350
intermittent (BAR)
400
Solenoid voltage (VDC)
24, (12)
Power requirement (W)
14